The Model 9E series weld heads are available to weld tube or pipe sizes from 0.25” to 6.625” (6,35 to 168,3mm) O.D. Although these heads can weld straight lengths of tube or pipe or long-tangent fittings, their primary purpose is welding fittings with very short stick-out, such as: pipe elbows with short tangents, tees with short legs, short sanitary ferrules, etc. This is accomplished with an off-set electrode, positioned close to one side of the weld head. A single extra-wide tube clamp is used to support the weld head while a gas seal (to maintain shielding gas coverage) is used on the other side of the head.
- Built-in water-cooling manifolds - When used with the 207-CW or 107-CW water cooling units, the internal weld head components and the weld head cables are cooled, allowing high duty-cycle welding of wall thicknesses up to approximately 0.154” (3,9mm)
- Conversion kits are available for most Model 9E series heads
- Compatible with Arc Machines’ 207, 227, 207-HP and 415 power supplies
|
|
|
|
|
| Model 9E-2500 welding 1.50" (38,1mm) O.D. short sanitary ferrule to tube stubs on a separator plate. |
|
 |
| Model 9E series off-set weld heads are available in five sizes. Models 9E-1500, 9E-3500, and 9E-4500 shown. |
|
|
|
 |
| Model 9E-1500 with pipe elbow 1.315" (33,4mm) O.D. |
|
|
|
|
|
|
|
|
|
|
Conversion Kits for All Model 9 Weld Heads
|
Most Model 9 series weld heads may be converted to an alternate configuration (Model 9, 9AF, 9E, or 9CT) by installing a conversion kit. For example: A basic Model 9-1500 may be converted to a 9E-1500, 9AF-1500, 9CT-1500 or vice-versa. The conversion takes 5-10 minutes, using only a screwdriver and a hex wrench.
|
|
Model 9AF |
Model 9E |
Model 9CT
|
| MODEL 9-500 |
|
|
• |
| MODEL 9AF-750 |
|
•
|
•
|
| MODEL 9-1500 |
•
|
•
|
•
|
| MODEL 9-2500 |
•
|
•
|
|
| MODEL 9-3500 |
•
|
•
|
|
| MODEL 9-4500 |
•
|
•
|
|
| MODEL 9-7500 |
•
|
•
|
|
|
Specifications subject to change without notice.
|
|
|
|
|
